# Full RV Awning Replacement in Chino > OCRV Center removes worn or wind-destroyed RV awnings and installs complete new assemblies, roller, arms, fabric, and controls, in shop in Yorba Linda. We fit and square the new unit to the coach and bill insurance direct. Sometimes the fabric, the arms, and the motor are all done, or a windstorm took the whole awning off the side of the coach. When the assembly is past piecemeal repair, a full replacement is the honest, lasting fix. We remove the old unit, inspect the mounting surface and the wall structure behind it, and install a complete new awning squared and sealed to the coach. ## What a full awning replacement includes A full replacement means a complete new assembly: roller tube with fabric, both arms, the mounting rail and brackets, and on powered units the motor, control module, and sensors. Before anything new goes up, we inspect the mounting rail and the sidewall behind it. Awnings that tore loose in wind often pull screws and damage the wall surface or the rail, and we are not going to bolt a new unit to a compromised mount. Any damage there gets addressed so the new awning has something solid to anchor to. We size the replacement to the coach: the correct extended length, the right projection so it clears doors and slides, and the mounting height that lets water shed instead of pooling. Manual or powered, we set the spring tension, square the arms so the roller runs parallel to the rail, set the travel locks, and on powered units program the limits and verify the wind sensor fires. The result is an awning that opens square, seals against the wall, and stows under control. - Complete assembly: roller, fabric, both arms, rail, brackets, and powered controls - Mounting rail and sidewall inspected and repaired before the new unit goes up - Replacement sized for extended length, projection, and mounting height - Arms squared, spring tensioned, and travel locks set so it stows controlled - Powered units programmed with open and close limits and wind sensor verified ## When replacement beats repair We do not push a full awning when a fabric swap or an arm repair will do. But there are clear cases where replacement is the cheaper path over time. When the fabric is rotted, an arm is cracked, and the spring is tired all at once, repairing each piece costs more than a new unit and still leaves you with an old assembly. When wind has ripped the awning off the rail, the arms and roller are usually bent beyond true and the unit comes as a set anyway. Replacement is also the moment to upgrade if it makes sense. If you bought a manual awning and have been fighting it for years, a powered unit with a wind sensor can go on in its place as long as the wall and wiring support it. We lay out the options honestly: repair what is worth repairing, replace what is past it, and only recommend the upgrade when the install is sound. - Worthwhile when fabric, arm, and spring have all failed together - The default after wind tears the awning off the rail and bends the hardware - Manual-to-powered upgrades possible where the wall and wiring support it - We recommend repair over replacement whenever the hardware is still sound ## Frequently asked questions ### When does a full awning replacement make more sense than repairing it? When the fabric is rotted, an arm is cracked, and the spring is tired all at the same time, repairing each piece adds up to more than a new unit and leaves you with an aging assembly. After a windstorm rips the awning off the rail, the arms and roller are usually bent beyond true and it comes as a set. We recommend repair whenever the hardware is still sound and replacement only when it genuinely costs less over time. ### Can you upgrade my manual awning to a powered one? Often yes, as long as the sidewall and wiring can support it. A full replacement is the natural moment to switch from a manual awning to a powered unit with a wind sensor. We confirm the wall structure and that we can route clean 12V power before we recommend it, so the upgrade is a sound install and not a problem waiting to happen. ### Will you check the wall behind the awning before installing a new one? Always. Awnings that tear loose in wind pull screws and can damage the mounting rail and the sidewall surface behind it. We are not going to anchor a new assembly to a compromised mount. We inspect the rail and wall in shop and repair any damage first so the new awning has something solid to bolt to. --- Source: https://oc-rv.com/services/full-awning-replacement/ OCRV Center, 23281 La Palma Ave, Yorba Linda, CA 92887. Phone (949) 799-3387. In shop only; insurance billed direct.